Page 1 of 1

Radarr not connecting but everything else is.

Posted: Sat Feb 25, 2017 9:45 pm
by lanstitch
I've got sabnzbd, my indexers, and Sonarr all connected and they all work. The only thing not working is Radarr. I've copied over the API (by emailing it to myself) twice. I've made sure that the ip adresses and port were correct. I don;t kow if there is a setting on Radarr's side I've got to set before it works but I haven't seen anything about this issue.

Re: Radarr not connecting but everything else is.

Posted: Sat Feb 25, 2017 10:33 pm
by f3bruary
Make sure the bind address is * or 0.0.0.0.

Also check if you can access Radarr through the browser. If not, then perhaps a firewall is blocking the connection ?

Re: Radarr not connecting but everything else is.

Posted: Sat Feb 25, 2017 11:24 pm
by lanstitch
My bind address is set to *. When I try to change it to 0.0.0.0 it tells me it failed to save general settings and tells me to switch it back to *. I can view Radarr on the host computer's browser but I can't view it on a remote browser. Whether it is on a local network or via the internet.

Re: Radarr not connecting but everything else is.

Posted: Sat Feb 25, 2017 11:42 pm
by Kev
Check your firewall and port forwarding settings.

Re: Radarr not connecting but everything else is.

Posted: Sun Feb 26, 2017 12:19 am
by lanstitch
I have disabled my firewall completely and double check my port forwarding. I now getting this error message inside NZB360 itself.

Re: Radarr not connecting but everything else is.

Posted: Sun Feb 26, 2017 1:10 pm
by lanstitch
I re-downloaded Radarr and set everything up again. It works now. I appreciate all the help.