Page 1 of 1

[FIXED]**"Select a Service" SabNZBD always shown

Posted: Sat Mar 01, 2014 10:10 pm
by Fafaffy
I'm using NZBGet instead of SabNZBD, however, whenever I press the back button, it shows me "SabNZBD".

Any way to hide this?

Note, you have to press the back button, it doesn't show when you're sliding the screen from the left to select a service.

Re: "Select a Service" SabNZBD always shown

Posted: Sat Mar 01, 2014 10:12 pm
by Kev
Ah, nice find! I'll have this fixed.

Re: [FIXED]**"Select a Service" SabNZBD always shown

Posted: Sun Mar 02, 2014 2:51 am
by Kev
Can someone verify this fix for me?

Re: [FIXED]**"Select a Service" SabNZBD always shown

Posted: Sun Mar 02, 2014 3:20 am
by Keelan
Kev wrote:Can someone verify this fix for me?
Is this when you navigate back and it gives you the choice to navigate to a different service or exit? If so then yes it now changes. However if you swap from Sabnzbd to nzbget (or visa versa) then you need to visit nzbget via the drop down to "reset" the back button menu to replace sabznbd to nzbget. Not an issue really because once it's done you shouldn't need to do it again.

Re: [FIXED]**"Select a Service" SabNZBD always shown

Posted: Sun Mar 02, 2014 4:46 am
by Fubduck
Kev wrote:Can someone verify this fix for me?
I can confirm this issue has been fixed.